Skip Ribbon Commands
Skip to main content

Water Heating

Photo example of how BGE helps customers through water heatingHeat Water Efficiently
Your business may use hot water  for 'domestic' purposes such as showers or washing hands in employee restrooms.  Or you may use it in specialized machines such as restaurant dishwashers or commercial laundry machines. No matter how you use water or how much you use, here are ways to cut back on unnecessary energy use.

Reduce Heat Loss
Install or repair insulation on the hot water storage tank and distribution pipes. If you have an uninsulated or poorly insulated hot water storage tank or uninsulated distribution pipes, adding an insulating jacket or 'wrap' to the tank and installing tubular insulation on the pipes will reduce 'stand-by' heat losses. If the tank is hot or warm to the touch, it needs insulation. Insulating your water tank and piping can reduce your energy consumption by as much as 4-9%. When insulating, be careful to leave openings for areas on your water heater that need to be accessed. Also, check with the tank manufacturer to make sure insulating your tank is not prohibited.

Reduce the temperature
Often the water heater control is set higher than necessary, to overcome heat losses from the tank and distribution pipes. A 10-degree reduction in water temperature can result in as much as 3-5% reduction in energy usage. With proper insulation of the storage tank and distribution pipes, you should be able to reduce the temperature control setting.

 

Use Less Water

Faucet aerators can reduce the amount of water flow to the tap by up to 50%. Installing occupancy sensing controls and automatic shut-off valves are other efficient ways to control water loss.
 
Maintenance
It always pays to make inexpensive repairs on leaky hot water faucets, showerheads, and pipe joints. Delaying a repair is not a good idea, since most leaks gradually get worse. You can make many repairs, such as replacing a sink faucet washer, quickly and easily, and at virtually no expense.

Other maintenance tips:
  • Test and adjust your fuel-fired heater
    A fuel-fired (gas or oil) water heater can waste energy if it is not burning the fuel properly. Have such a heater checked to see if excess heat is being lost.
  • Turn off the circulation pump
    Consider turning the circulation system off when your space is unoccupied and hot water is not needed. You can install a simple timer to do this.
  • Clean out sediment
    Any tank-type water heater will lose efficiency if sediment accumulates in the bottom and acts as an internal insulator to inhibit transfer of heat from the heating elements to the water. To make sure these deposits don't build up, periodically open the drain valve near the bottom of the tank and draw off water until it runs clear and the sediment has been removed. Get a technician to do this for large commercial equipment.
Change to a high efficiency or tankless water heater
If you are replacing your water heater, replace with high efficiency units. As with most energy using replacements, the additional cost for a high efficiency model is quickly paid back in energy cost savings.
  
Consider a heat pump water heater
One of the most energy efficient water heaters is a heat pump water heater (HPWH). It is available either as an integral unit incorporating a storage tank, or as an add-on to your present water heater where the heat pump heats the water and the storage tank stores it.
 
For more information, visit BGE Smart Energy Savers Program®
© Baltimore Gas and Electric Company, 2021. All Rights Reserved.